Chemical resistance of HPL
Magnet HPL type S
Decorative magnetic high-pressure laminate.
The back side is sanded for gluing.
Field of application
- Furniture construction, interior and shop fitting, trade fair construction, partition walls, offices, museums, public institutions.
Magnet HPL type S
| Sizes in mm | Thickness in mm | Textures | |
|---|---|---|---|
| Length | Width | ||
| 2,750 | 2,020 | 1.2 | 47 | 49 |
Decorative magnetic high-pressure laminate.
The back side is sanded for gluing.
Product standard
- leaned on EN 438-3
Reaction to fire
- normally inflammable
Formaldehyde emission class
- E1 (EN 717-1)
Chemical resistance
- Resistant to organic solvents, weak acids, petrol and oil. (EN 438-2)
Cleaning and care
- The surface can be cleaned with water and gentle cleaning agents. To remove stubborn stains, please observe the recommendations in the data sheet "Cleaning of HPL surfaces".
Product safety
- The surface is physiologically safe, and approved for direct contact with food.
- This product is following the REACH regulation EG 1907/2006 an article. Following Article 7 it needs not to be registered.
- The material is not rated as hazardous material.
Special
- We recommend the use of Uni-designs.
- The colour may differ slightly from HPL with overlay.
- Alu 1, 2 and 4 are not possible.
- Slight deviations in the structure compared with the standard product cannot be avoided because of the metal inserts.
- Full-size boards have a non-magnetic border approx. 2 cm wide.
- Cut to size is not available.
Downloads
Magnet HPL type S
Certificates
Magnet HPL type S
Processing
- In general watch out for flying sparks! Switch-off any extraction / vacuum. Single sheet cut with the decorative side facing up. All carbide tipped tools with firmly soldered blades and drawing cut are suitable, do not use diamond tools. Trial cuts are recommended.
- For the production of composite elements we recommend a symmetric construction. This means both sides identical HPL. If backing material (also HPL) is used, there is a risk of shape distortion (bowing). Tests will be necessary.
Installation and assembly
- Sufficient conditioning is required prior to installation and assembly. The premises themselves need to be air-conditioned according to future use.
Storage and handling
- On all level surfaces (e.g. pallets), in dry, vented rooms.
Disposal
- Energy recovery in incinerators is recommended.
